Insights
Packaging Insights & Regulatory Updates
Material selection notes, regulatory updates and company news for packaging engineers and procurement teams.

Metallized Barrier Film vs PVDC-Coated PVC: Choosing the Right Barrier
2026-11-05
Metallized film and PVDC-coated PVC both raise barrier above plain PVC, but they raise it in different ways and at different cost points. This note compares the two routes on moisture and oxygen performance, machine behaviour, print and sustainability, so the barrier decision can be made against the product rather than against a datasheet headline.

Strip Packaging vs Blister for Unit-Dose Solids: A Selection Checklist
2026-11-04
Strip packs and blisters both give unit-dose presentation, but they suit different products, machines and markets. This note compares the two formats on barrier, machine fit, pack geometry and documentation, and lists the points worth settling before tooling is ordered.

PTP Aluminium Foil Pinholes: Causes, Detection and What to Specify
2026-11-03
A blister foil can be within gauge and still fail on pinholes, because pinholes come from rolling, handling and forming rather than from thickness alone. This note explains where they originate, how they are detected on a running line, and which specification points make the difference contractual rather than assumed.

Recyclable Blister Packaging Under the EU PPWR: What to Specify Now
2026-11-02
The EU Packaging and Packaging Waste Regulation pushes blister packs toward design-for-recycling, but recyclability depends on the material stream, the lidding and the collection scheme in each market. This note sets out how PVC, PVC/PVDC, PVC/APET laminates, APET and RPET sit against those requirements, and the specification points worth fixing before tooling and validation.

Medical Device Tray Materials: APET, RPET and PVC/APET Laminates Compared
2026-10-30
Device trays are usually specified after the device and the sterile barrier are fixed, which makes the material choice a validation decision rather than a cost decision. This note compares APET, RPET and PVC/APET laminated sheet on clarity, stiffness, forming behaviour, sterilisation compatibility and recycled content, and lists the checks worth running before the tray is committed to tooling.

Cold-Form Foil vs High-Barrier Film: Choosing the Right Structure for Moisture-Sensitive Tablets
2026-10-29
Two structures dominate moisture protection for solid dosage forms. This note compares cold-form aluminium and high-barrier blister film on barrier performance, tooling, line compatibility and cost, so packaging engineers can choose with the stability data in hand.

Diagnosing Thermoforming Defects: Webbing, Thinning and Stress Whitening
2026-10-28
Webbing, uneven thinning and stress whitening usually point to a mismatch between the forming window, the tooling and the film grade. A practical checklist for tracing the cause before changing material.

MVTR Explained: What Moisture Vapour Transmission Rate Means for Blister Packaging
2026-10-27
MVTR data appears on every film data sheet, but the number only means something when the test conditions and the finished pack are taken into account. A practical guide to reading and comparing barrier data.

Choosing Lidding Materials: Aluminum Foil, Film and Paper Options
2026-10-26
Lidding selection comes down to barrier, seal integrity and how the pack is opened. A practical comparison of aluminum foil, film and paper-based lids for blister packs and display trays.